20CrMnTi钢管厂

精密钢管长度与外形的相关要求!

精密钢管长度和外形有哪些要求?下面无缝钢管厂就来给大家说说! 国内现在一般厂家生产的精密钢管的长度为2000~12000mm,对定尺和倍尽长度的规定为:精密钢管定尺长度及倍尺总长度应在通常长度范围内,当精密钢管的长度≤5000mm时,全长允许偏差为0~5mm;长度>5000mm时,全长允许偏差为0~10mm,每个倍尺长度的精密钢管应留出的切口裕量为:外径≤159mm时,留出的切口裕量为5~10mm;当精密钢管的外径>mm时,留出的切口裕量为10~15mm。 在对精密钢管的外径要求上,一般对精密钢管的弯曲度应不大于3.0mm/m。外径大于16mm的精密钢管全长弯曲度按上屈服强度Reh的不同,应符合以下规定:Reh≤500MPa,≤0.15%L;Reh>500MPa,≤0.20%L。如果精密钢管的供求双方经过协议,每米弯曲度和全长弯曲度可采用其他的规定。 不圆度方面,精密钢管的不圆度应不大于外径公差的80%;当精密钢管的壁厚不均,供求双方应妥当协商。 Precision steel tube length and shape what are the requirements?Seamless steel pipe to give us the below! Now the general domestic manufacturers in the production of precision steel tube length is 2000 ~ 12000 mm, the length of the length and times of provisions for: precision steel pipe specified length and times' total length should be the length range, usually when precision steel tube length is 5000 mm or less, total length of allowable deviation of 0 ~ 5 mm;Length > 5000 mm, the total length of the allowable deviation of 0 ~ 10 mm, each times ruler length of precision steel tube should be set aside the incision of allowance for: outer diameter 159 mm or less, to set aside the incision of allowance for 5 ~ 10 mm;When > mm precision steel tube diameter, set aside the incision of allowance for 10 ~ 15 mm. On the requirements of precision steel tube diameter, the general precision steel tube bending should be no greater than 3.0 mm/m.Diameter greater than 16 mm length of precision steel tube bending on the yield strength of the Reh, shall meet the following requirements: Reh acuities were 500 mpa, 0.15% or less L;Reh > 500 mpa, 0.20% or less L.If the supply and demand both sides precision steel tube agreement, bending per meter and the total length of bending can adopt the rules of the other. Out of roundness, the out of roundness of precision steel tube should be not greater than 80% of the outside diameter tolerance;When the precision of steel tube wall thickness uneven, both supply and demand should be appropriate to negotiate. 标签:[db:标签]